Programmable Logic Controller Guide: Selection, Application, and Maintenance for Engineers
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
The Siemens 6ES7526-2BF00-0AB0 is a SIMATIC S7-1500 fail-safe digital output module with 8 channels rated 24 VDC at 2 A per channel, using PROFIsafe (PPM) over PROFINET or PROFIBUS. It reaches PL e per ISO 13849-1 and SIL 3 per IEC 61508, with a PFH below 2.00E-09 1/h for safety-related output switching.
The 2 A per-channel rating and PL e / SIL 3 classification make this a main safety-output module for switching contactor coils or safety valves directly, rather than only pilot-level loads. PROFIsafe over the existing PROFINET or PROFIBUS network carries the safety telegram without separate safety wiring back to the F-CPU, which cuts cabinet wiring versus a hardwired safety relay approach. The 35 mm module width and 0-40 °C vertical-install ceiling are worth checking against enclosure layout and cooling before specifying a dense safety I/O rack.
Safety-related digital output switching for emergency-stop circuits, guard-door interlocks, and safety valve control in machines with an F-CPU and PROFIsafe network.
| Product type designation | F-DQ 8x24VDC/2A PPM |
|---|---|
| Firmware version: FW update possible | Yes |
| Product function: I&M data | Yes; I&M0 to I&M3 |
| Engineering with: STEP 7 TIA Portal configurable/integrated from version | V13 SP1 with HSP 0086 |
| Operating mode: DQ | Yes |
| Operating mode: MSO | No |
| Rated value (DC) | 24 V |
|---|---|
| permissible range, lower limit (DC) | 19.2 V |
| permissible range, upper limit (DC) | 28.8 V |
| Reverse polarity protection | Yes |
| power supply according to NEC Class 2 required | No |
| Current consumption (rated value) | 110 mA; without load |
|---|---|
| Current consumption, max. | 130 mA; without load |
| Part number | 6ES7526-2BF00-0AB0 |
|---|---|
| Type designation | F-DQ 8x24VDC/2A PPM |
| Brand | Siemens |
| Condition | New, factory sealed |
| Source | Siemens and its authorised distributors |
| Warranty | Manufacturer warranty |
| Lifecycle status | Active, in production |
| EAN | 4047623405962 |
| ETIM class | EC001419 |
| eCl@ss | 27242204 |
| Rated value (DC) | 24 V |
|---|
| Power consumption from the backplane bus | 0.8 W |
|---|
| Power loss, typ. | 11 W |
|---|
| Address space per module: Inputs | 6 byte; S7-300/400F CPU, 5 byte |
|---|---|
| Address space per module: Outputs | 6 byte; S7-300/400F CPU, 5 byte |
| Automatic encoding | Yes |
|---|---|
| Electronic coding element type F | Yes |
| Number of digital outputs | 8 |
|---|---|
| Current-sinking | Yes |
| Current-sourcing | Yes |
| Short-circuit protection | Yes |
| Open-circuit detection | Yes |
| Response threshold, typ. | 8 mA |
| Overload protection | Yes |
| Limitation of inductive shutdown voltage to | PM-switching: -24 V + (-47 V), PP-switching: -24 V |
| Controlling a digital input | Yes; digital output, according to IEC 61131-2, type 2 |
| Switching capacity of the outputs: with resistive load, max. | 2 A |
| Switching capacity of the outputs: on lamp load, max. | 10 W |
| Load resistance range: lower limit | 12 Ω |
| Load resistance range: upper limit | 2 000 Ω |
| Output voltage: for signal "1", min. | 24 V; L+ (-0.5 V) |
| Output current: for signal "1" rated value | 2 A |
| Output current: for signal "0" residual current, max. | 0.5 mA; Current-sourcing, or current sourcing and sinking switches individually, current sinking: max. 1 mA |
| Switching frequency: with resistive load, max. | 30 Hz |
| Switching frequency: with inductive load, max. | 0.1 Hz |
| Switching frequency: on lamp load, max. | 10 Hz |
| Total current of the outputs: Current per channel, max. | 2 A |
| Total current of the outputs (per module) horizontal installation: up to 40 °C, max. | 16 A |
| Cable length: shielded, max. | 1 000 m |
| Cable length: unshielded, max. | 500 m |
| Diagnostics function | Yes |
|---|---|
| Substitute values connectable | No |
| Alarms: Diagnostic alarm | Yes |
| Diagnoses: Monitoring the supply voltage | Yes |
| Diagnoses: Wire break | Yes |
| Diagnoses: Short-circuit | Yes |
| Diagnoses: Group error | Yes |
| Diagnostics indication LED: RUN LED | Yes; green LED |
| Diagnostics indication LED: ERROR LED | Yes; red LED |
| Diagnostics indication LED: Monitoring of the supply voltage (PWR-LED) | Yes |
| Diagnostics indication LED: Channel status display | Yes; green LED |
| Diagnostics indication LED: for channel diagnostics | Yes; red LED |
| Diagnostics indication LED: for module diagnostics | Yes; red LED |
| Potential separation channels: between the channels | No |
|---|---|
| Potential separation channels: between the channels and backplane bus | Yes |
| Isolation tested with | 707 V DC (type test) |
|---|
| Suitable for safety functions | Yes |
|---|---|
| Highest safety class achievable in safety mode: Performance level according to ISO 13849-1 | PLe |
| Highest safety class achievable in safety mode: SIL acc. to IEC 61508 Probability of failure (for service life of 20 years and repair time of 100 hours) | SIL 3 |
| Highest safety class achievable in safety mode: Low demand mode: PFDavg in accordance with SIL3 | < 6.00E-05 |
| Highest safety class achievable in safety mode: High demand/continuous mode: PFH in accordance with SIL3 | < 2.00E-09 1/h |
| Ambient temperature during operation: horizontal installation, min. | 0 °C |
|---|---|
| Ambient temperature during operation: vertical installation, min. | 0 °C |
| Width | 35 mm |
|---|---|
| Height | 147 mm |
| Depth | 129 mm |
| Weight, approx. | 300 g |
|---|
| Net weight | 0.373 kg |
|---|---|
| Country of origin | DE |
| Shipping weight | 0.873 kg |
| Ships from | Türkiye |
| Dispatch | 18 Nov |
| Stock | In stock |
Source: manufacturer data · Last verified: 01 Nov 2026
No documents are on file for this part yet.
Ask us for the datasheetThe rated current of F-DQ 8x24VDC/2A PPM is 2 A.
The rated operational voltage of F-DQ 8x24VDC/2A PPM is 24 V DC.
The tariff (HS) code on file for F-DQ 8x24VDC/2A PPM is 85389091.
The EAN (GTIN) of F-DQ 8x24VDC/2A PPM is 4047623405962.
F-DQ 8x24VDC/2A PPM ships from Türkiye. Shipping calculated at checkout · import duties and taxes paid on arrival. Stock items are dispatched within 1–2 business days.
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Learn how a PLC works, including scan cycle, I/O sizing, IEC 61131-3 programming, and hardware selection for ABB, Schneider, and Siemens. Shop at Stoklink.
Master PLC system components: CPU, power supply, I/O modules, communication interfaces, and software with sizing formulas and selection tips. Shop at Stoklink.