Programmable Logic Controller Guide: Selection, Application, and Maintenance for Engineers
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Once production ends, supply depends on remaining stock.
No replacement announced yet. Tell us the application and we will propose an alternative.
The Siemens FM 450-1 (6ES7450-1AP01-0AE0) is a 2-channel counter function module for the SIMATIC S7-400 rack, handling incremental or pulse encoder signals up to 500 kHz on 5 V RS422 inputs and up to 200 kHz on 24 V inputs. It adds 6 parameterizable digital inputs and 4 digital outputs for gate control and threshold switching, and ships with a CD configuration package.
The 5 V RS422 counter input reaches 500 kHz versus 200 kHz on the 24 V input, so wire the RS422 side when the encoder outputs differential 5 V signals and the application needs the higher pulse rate. The 32-bit (or +/-31-bit) counting range covers long-run length measurement without rollover. Six digital inputs are parameterizable for gate start, gate stop, and counter preset, so the gating logic runs in the module rather than the CPU cycle. Four digital outputs, rated 0.5 A with electronic short-circuit protection, switch directly off comparator thresholds for limit or preset alarms.
Typical uses include length measurement on cut-to-length and winding lines, position tracking on conveyors, and packaging machinery where a 500 kHz encoder signal needs hardware-level counting inside an S7-400 rack.
| Auxiliary voltage 1L+, load voltage 2L+: Rated value (DC) | 24 V |
|---|---|
| Auxiliary voltage 1L+, load voltage 2L+: permissible range, lower limit (DC) | 20.4 V; Dynamic 18.5 V |
| Auxiliary voltage 1L+, load voltage 2L+: permissible range, upper limit (DC) | 28.8 V; dynamic 30.2 V |
| from load voltage 1L+ (without load), max. | 50 mA |
|---|---|
| from load voltage 2L+ (without load), max. | 60 µA |
| from backplane bus 5 V DC, max. | 300 mA |
| ●5V | Yes; 5.2 V ±2 % |
|---|---|
| Short-circuit protection | Yes |
| Output current, max. | 300 mA |
| 24 V encoder supply: 24 V | Yes; 1L+ (-3 V) |
| 24 V encoder supply: Short-circuit protection | Yes |
| 24 V encoder supply: Output current, max. | 300 mA |
| Part number | 6ES7450-1AP01-0AE0 |
|---|---|
| Brand | Siemens |
| Condition | New, factory sealed |
| Source | Siemens and its authorised distributors |
| Warranty | Manufacturer warranty |
| Lifecycle status | Phase-out announced by the manufacturer |
| EAN | 4019169229005 |
| Power loss, typ. | 6 W |
|---|
| Number of digital inputs | 6 |
|---|---|
| Functions | 1 for gate start, 1 for gate stop, 1 for setting the counter |
| Input voltage: for signal "0" | -28.8 ... +5V |
| Input voltage: for signal "1" | +11 to +28.8V |
| Input current: for signal "1", typ. | 9 mA |
| Input delay (for rated value of input voltage): Input frequency (with a time delay of 0.1 ms), max. for standard inputs | 200 kHz |
| Input delay (for rated value of input voltage): parameterizable | Yes |
| Input delay (for rated value of input voltage): at "0" to "1", max. | 2.5 µs; ≥ 2.5 µs (200 kHz); ≤ 25 µs (20 kHz) |
| Number of digital outputs | 4 |
|---|---|
| Short-circuit protection | Yes; Clocked electronically |
| Limitation of inductive shutdown voltage to Output voltage | 2L+ (-39 V) |
| for signal "0", max. | 3 V |
| for signal "1", min. | 2L+ (-1,5 V) |
| Output current: for signal "1" rated value | 0.5 A; Res. / P.D. 5 W tungsten 24 V DC |
| Output current: for signal "1" permissible range for 0 to 60 °C, min. | 5 mA |
| Output delay with resistive load: "0" to "1", max. | 300 µs |
| Connectable encoders: Incremental encoder (symmetrical) | Yes; With 2 pulse trains offset by 90° |
|---|---|
| Connectable encoders: Incremental encoder (asymmetrical) | Yes |
| Connectable encoders: 24 V initiator | Yes |
| Connectable encoders: 24 V directional element | Yes; 1 pulse train, 1 direction level |
| Status indicator | Yes; 14 green LEDs for status of CR, DIR, inputs and outputs |
|---|---|
| Diagnostics function | Yes |
| Alarms: Diagnostic alarm | Yes; Parameterizable |
| Alarms: Hardware interrupt | Yes; Parameterizable |
| Diagnoses: Diagnostic information readable | Yes |
| Diagnostics indication LED: internal fault INTF (red) | Yes |
| Diagnostics indication LED: external fault EXTF (red) | Yes |
| Diagnostics indication LED: Status indicator digital input (green) | Yes |
| Diagnostics indication LED: Status indicator digital output (green) | Yes |
| Number of counter inputs | 2; 32 bit or ±31 bit |
|---|---|
| Counter input 5 V: Type | RS 422 |
| Counter input 5 V: terminating resistor | 220 Ω |
| Counter input 5 V: Differential input voltage | min. 0.5 V |
| Counter input 5 V: Counting frequency, max. | 500 kHz |
| Counter input 24 V: Input voltage for signal "0" | -30 to +5 V |
| Counter input 24 V: Input voltage for signal "1" | +11 to +30V |
| Counter input 24 V: Input current for signal "1", typ. | 9 mA |
| Counter input 24 V: Counting frequency, max. | 200 kHz |
| Counter input 24 V: Minimum pulse width | ≥ 2.5 µs (200 kHz); ≥ 25 µs (20 kHz) (parameterizable) |
| Potential separation digital inputs: between the channels and backplane bus | Yes; Optocoupler |
|---|---|
| Potential separation digital outputs: between the channels and backplane bus | Yes; Optocoupler |
| Potential separation counter: between the channels and backplane bus | Yes; Optocoupler |
| Isolation tested with | 500 V |
|---|
| required front connector | 1x 48-pin |
|---|
| Width | 25 mm |
|---|---|
| Height | 290 mm |
| Depth | 210 mm |
| Weight, approx. | 650 g |
|---|
| eClass | 16 27-24-22-05 |
|---|---|
| ETIM | 10 EC001422 |
| IDEA | 4 3567 |
| UNSPSC | 15 32-15-17-05 |
| Net weight | 0.82 kg |
|---|---|
| Country of origin | DE |
| Shipping weight | 1.32 kg |
| Ships from | Türkiye |
| Dispatch | 18 Nov |
| Stock | Low stock |
Source: manufacturer data · Last verified: 01 Nov 2026
No documents are on file for this part yet.
Ask us for the datasheetThe rated current of 6ES7450-1AP01-0AE0 is 0.5 A.
The tariff (HS) code on file for 6ES7450-1AP01-0AE0 is 85389091.
The EAN (GTIN) of 6ES7450-1AP01-0AE0 is 4019169229005.
6ES7450-1AP01-0AE0 ships from Türkiye. Shipping calculated at checkout · import duties and taxes paid on arrival. Stock items are dispatched within 1–2 business days.
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Learn how a PLC works, including scan cycle, I/O sizing, IEC 61131-3 programming, and hardware selection for ABB, Schneider, and Siemens. Shop at Stoklink.
Master PLC system components: CPU, power supply, I/O modules, communication interfaces, and software with sizing formulas and selection tips. Shop at Stoklink.