Programmable Logic Controller Guide: Selection, Application, and Maintenance for Engineers
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Once production ends, supply depends on remaining stock.
No replacement announced yet. Tell us the application and we will propose an alternative.
The Siemens 6ES7322-5RD00-0AB0 is a SIMATIC S7-300 SM 322 digital output module with 4 isolated outputs rated 15 V / 20 mA, built to drive actuators located in a hazardous area. It draws 160 mA from the 24 V DC load supply, is PTB tested under number Ex-96.D.2102X, and carries an [EEx ib] IIC hazardous-area marking.
At 15 V / 20 mA rated output, this module suits intrinsically safe actuators whose loop is specified for that voltage/current pair rather than the 24 V / 10 mA pair used on the other SM 322 output variant — check the actuator's own Ex(i) entity parameters against Uo 15.75 V / Io 85 mA / Po 335 mW before mixing modules on the same project. The 200 Ohm maximum load resistance sets the longest field-wiring loop the output can drive at rated current; a lower-resistance actuator leaves margin, a higher one will not reach rated current. Short-circuit protection is electronic, so a field fault trips without replacing a fuse.
| Load voltage L+: Rated value (DC) | 24 V |
|---|---|
| Load voltage L+: Reverse polarity protection | Yes |
| from load voltage L+ (without load), max. | 160 mA |
|---|---|
| from backplane bus 5 V DC, max. | 85 mA |
| Power loss, typ. | 3 W |
|---|
| Part number | 6ES7322-5RD00-0AB0 |
|---|---|
| Brand | Siemens |
| Condition | New, factory sealed |
| Source | Siemens and its authorised distributors |
| Warranty | Manufacturer warranty |
| Lifecycle status | Phase-out announced by the manufacturer |
| EAN | 4025515061076 |
| Number of digital outputs | 4 |
|---|---|
| Short-circuit protection | Yes; Electronic |
| Response threshold, typ. | Output current with short-circuit protection, min. 20.5 mA + 10 % |
| Load resistance range: upper limit | 200 Ω; Two-wire connection |
| Output voltage: Rated value (DC) | 15 V |
| Output current: for signal "1" permissible range for 0 to 60 °C, max. | 20 mA; ±10 % |
| Switching frequency: with resistive load, max. | 100 Hz |
| Cable length: unshielded, max. | 200 m |
| Diagnostics function | Yes |
|---|---|
| Diagnoses: Diagnostic information readable | Yes |
| Diagnoses: Short-circuit | Yes |
| Diagnostics indication LED: Group error SF (red) | Yes |
| Diagnostics indication LED: Status indicator digital output (green) | Yes |
| Diagnostics indication LED: Channel fault indicator F (red) | Yes |
| Module for Ex(i) protection | Yes |
|---|---|
| maximum values for connecting terminals for gas group IIC: Uo (no-load voltage), max. | 15.75 V |
| maximum values for connecting terminals for gas group IIC: Io (short-circuit current), max. | 85 mA |
| maximum values for connecting terminals for gas group IIC: Po (power output), max. | 335 mW |
| maximum values for connecting terminals for gas group IIC: Co (permissible external capacity), max. | 500 nF |
| maximum values for connecting terminals for gas group IIC: Lo (permissible external inductivity), max. | 5 mH |
| Potential separation digital outputs: between the channels | Yes; 60 V DC/30 V AC when used in the hazardous area; 400 V DC/250 V AC when used in NON-hazardous area |
|---|---|
| Potential separation digital outputs: between the channels, in groups of | 1 |
| Potential separation digital outputs: between the channels and backplane bus | Yes; 60 V DC/30 V AC when used in the hazardous area; 400 V DC/250 V AC when used in NON-hazardous area |
| Use in hazardous areas: ATEX marking | [EEx ib] IIC |
|---|---|
| Use in hazardous areas: FM marking | AIS CL.1, DIV 1, GP A, B, C, D; CL.I, DIV 2, GP A, B, C, D T4 |
| Use in hazardous areas: Test number PTB | Ex-96.D.2102X |
| Ambient temperature during operation: max. | 60 °C |
|---|
| required front connector | 20-pin |
|---|
| Width | 40 mm |
|---|---|
| Height | 125 mm |
| Depth | 120 mm |
| Weight, approx. | 230 g |
|---|
| Miscellaneous Manufacturer Declara- | tion |
|---|
| Net weight | 0.4 kg |
|---|---|
| Country of origin | DE |
| Shipping weight | 0.9 kg |
| Ships from | Türkiye |
| Dispatch | — |
| Stock | On request |
Source: manufacturer data · Last verified: 01 Nov 2026
No documents are on file for this part yet.
Ask us for the datasheetThe rated operational voltage of 6ES7322-5RD00-0AB0 is 15 V AC.
The tariff (HS) code on file for 6ES7322-5RD00-0AB0 is 85389091.
The EAN (GTIN) of 6ES7322-5RD00-0AB0 is 4025515061076.
6ES7322-5RD00-0AB0 ships from Türkiye. Shipping calculated at checkout · import duties and taxes paid on arrival.
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Learn how a PLC works, including scan cycle, I/O sizing, IEC 61131-3 programming, and hardware selection for ABB, Schneider, and Siemens. Shop at Stoklink.
Master PLC system components: CPU, power supply, I/O modules, communication interfaces, and software with sizing formulas and selection tips. Shop at Stoklink.