Programmable Logic Controller Guide: Selection, Application, and Maintenance for Engineers
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
The Siemens 6ES7154-4AB10-0AB0 is a SIMATIC ET 200pro interface module (IM 154-4 PN HF) that connects the ET 200pro I/O station to PROFINET IO via an integrated switch with 100 Mbit/s autonegotiation and IRT support. It runs from a 24 V DC supply, addresses 256 bytes of inputs and 256 bytes of outputs, and supports PROFIsafe and MRP media redundancy.
The High Feature (HF) designation is what enables IRT and PROFIsafe on this module, so it is the interface module to pick when the ET 200pro station sits on an isochronous PROFINET segment or carries F-modules that need fail-safe communication; hot swapping is supported for module replacement without powering down the station. The integrated switch means no external PROFINET switch is needed to continue the line topology to the next station. A connection/termination module (6ES7194-4A..-0AA0) is required and must be ordered separately to complete the mechanical mounting.
Head/interface module for an ET 200pro remote I/O station on a PROFINET line topology, particularly where motion-synchronized (isochronous) I/O or PROFIsafe fail-safe signals run over the same network segment as standard I/O.
| Product type designation | IM 154-4 PN HF |
|---|---|
| Vendor identification (VendorID) | 0x002A |
| Device identifier (DeviceID) | 0x0305 |
| Product function: IRT | Yes |
| Rated value (DC) | 24 V |
|---|---|
| Reverse polarity protection | Yes; against destruction |
| Short-circuit protection | Yes; Fuse in lower part is exchangeable, the fuse on the IM-LP is not |
| power supply according to NEC Class 2 required | No |
| Load voltage 2L+: Rated value (DC) | 24 V |
| Load voltage 2L+: Reverse polarity protection | Yes; against destruction |
| from supply voltage 1L+, max. | 400 mA; Dependent on terminal module, typ. maximum value for FO connection method, full load on RWB and 20.4 V input voltage |
|---|
| Part number | 6ES7154-4AB10-0AB0 |
|---|---|
| Type designation | IM 154-4 PN HF |
| Brand | Siemens |
| Condition | New, factory sealed |
| Source | Siemens and its authorised distributors |
| Warranty | Manufacturer warranty |
| Lifecycle status | Active, in production |
| EAN | 4025515075127 |
| ETIM class | EC001604 |
| eCl@ss | 27242608 |
| Power loss, typ. | 6 W; dependent on terminal module, typ. maximum value for CU connection method, full load on RWB, for FO the value is approx. 0.7 W higher |
|---|
| Address space per module: Inputs | 256 byte |
|---|---|
| Address space per module: Outputs | 256 byte |
| Interfaces/bus type | PROFINET IO |
|---|
| M12 port: Autonegotiation | Yes |
|---|---|
| M12 port: Transmission rate, max. | 100 Mbit/s |
| Supports protocol for PROFINET IO | Yes |
|---|---|
| PROFIsafe | Yes |
| PROFIBUS | No |
| EtherNet/IP | No |
| Protocols (Ethernet): SNMP | Yes |
| Protocols (Ethernet): ping | Yes |
| Protocols (Ethernet): ARP | Yes |
| Redundancy mode Media redundancy: MRP | Yes |
| Alarms: Diagnostic alarm | Yes; Parameterizable |
|---|---|
| Alarms: Hardware interrupt | Yes; Parameterizable |
| Diagnostics indication LED: MAINT LED | Yes |
| Diagnostics indication LED: LINK LED | Yes |
| Diagnostics indication LED: RX/TX LED | Yes |
| Diagnostics indication LED: For load voltage monitoring | Yes |
| Diagnostics indication LED: Bus fault BF (red) | Yes |
| Diagnostics indication LED: Group error SF (red) | Yes |
| Diagnostics indication LED: Monitoring 24 V voltage supply ON (green) | Yes |
| Swapping interrupt | Parameterizable |
|---|---|
| Startup if setpoint not equal to actual configuration | Parameterizable |
| Hot swapping of modules | possible |
| between backplane bus and electronics | No |
|---|---|
| between supply voltage and electronics | Yes |
| Isolation tested with | 707 V DC (type test) |
|---|
| Ambient temperature during operation: min. | -25 °C |
|---|---|
| Ambient temperature during operation: max. | 55 °C |
| Ambient temperature during storage/transportation: min. | -40 °C |
| Ambient temperature during storage/transportation: max. | 70 °C |
| Width | 135 mm |
|---|---|
| Height | 130 mm |
| Depth | 60 mm |
| Weight, approx. | 490 g |
|---|
| Net weight | 0.54 kg |
|---|---|
| Country of origin | DE |
| Shipping weight | 1.04 kg |
| Ships from | Türkiye |
| Dispatch | 18 Nov |
| Stock | Low stock |
Source: manufacturer data · Last verified: 01 Nov 2026
No documents are on file for this part yet.
Ask us for the datasheetThe rated operational voltage of IM 154-4 PN HF is 24 V AC.
The tariff (HS) code on file for IM 154-4 PN HF is 85176200.
The EAN (GTIN) of IM 154-4 PN HF is 4025515075127.
IM 154-4 PN HF ships from Türkiye. Shipping calculated at checkout · import duties and taxes paid on arrival. Stock items are dispatched within 1–2 business days.
PLC selection guide for engineers covering IEC 61131 compliance, Siemens, Rockwell, Schneider, ABB comparison, scan time sizing, and wiring. Shop at Stoklink.
Learn how a PLC works, including scan cycle, I/O sizing, IEC 61131-3 programming, and hardware selection for ABB, Schneider, and Siemens. Shop at Stoklink.
Master PLC system components: CPU, power supply, I/O modules, communication interfaces, and software with sizing formulas and selection tips. Shop at Stoklink.